Cart

0

Arduino Nano 33 BLE Sense REV2

19.50 د.ك

Small, powerful, BT connected and with all the sensors you may need to design innovative applications.

In stock

Description

The Nano 33 BLE Sense Rev2 is Arduino’s 3.3V AI enabled board in the smallest available form factor with a set of sensors that will allow you without any external hardware to start programming your next project, right away.

With the Arduino Nano 33 BLE Sense Rev2 in combination with on-board sensor, you can:

  • Build wearable devices that using AI can recognize movements.
  • Build a room temperature monitoring device that can suggest or modify changes in the thermostat.
  • Build a gesture or voice recognition device using the microphone or the gesture sensor together with the AI capabilities of the board.

The main feature of this board, besides the complete selection of sensors, is the possibility of running Edge Computing applications (AI) on it using TinyML. Learn how to use the Tensor Flow Lite library following this instructions or learn how to train your board using Edge Impulse.

Small, powerful, BT connected and with all the sensors you may need to design innovative applications.

Its architecture, fully compatible with Arduino IDE Online and Offline, has a 9 axis Inertial Measurement Unit (IMU), temperature, pressure, humidity, light, color and even gestures sensors that are managed through our specialized libraries. Its reduced power consumption, compared to other same size boards, together with the NANO form factor opens up a wide range of applications.

This allows the design of wearable devices and gesture based projects that need to communicate to other devices at a close range. Arduino Nano 33 BLE Sense is ideal for interactive automation projects thanks to the multiprotocol BT 5.0 radio.

 

  • 1x Arduino Nano 33 BLE Sense Board
  • 2x 15 Pin Headers

Rev.2 Notes: • The LSM9DS1 inertial sensor (9 axes) is replaced by a combination of two sensors – BMI270 (6 axes) u. BMM150 (3 axes).
• HS3003 temperature and humidity sensor is replaced by HTS221 sensor
• MP2322 is replaced by MPM3610
• PCB design change – VSUB solder jumper on top of board / USB testpoint on bottom / SWDIO + SWCLK testpoint on top & bottom

 

  • Microcontroller: nRF52840
  • Operating Voltage: 3.3V
  • Input Voltage (limit): 21V
  • DC Current per I/O Pin: 15mA
  • Clock Speed: 64MHz
  • CPU Flash Memory: 1MB
  • SRAM: 256KB
  • EEPROM: None
  • Digital Input/Output Pins: 14
  • PWM: All digital pins
  • Interfaces: 1 UART, 1 SPI, 1 I2C
  • Analog Input Pins: 8 (ADC 12 bit 200 ksamples)
  • Analog Output Pins: Only through PWM (no DAC)
  • External Interrupts: All digital pins
  • LED_BUILTIN: 13
  • USB
  • Microphone: MP34DT05
  • Gesture, Light, Proximity: APDS9960
  • Barometric Pressure: LPS22HB
  • Temperature, Humidity: HTS221
  • Dimensions: 45x18mm